[ Chinese wardrobe net ] 1. According to the shape of the beam and the pillar, the pillar plate and the cladding beam plate can be designed to hide the beam and the pillar, and not to be exposed, so that the wardrobe forms a joint body and achieves reasonable utilization of the space.
2. The 18mm thick plate should be used for the column and the cladding beam to ensure that the assembled wardrobe is firm.
3. With the position of the pillar, design its façade space as a laminate for stacking small items or a special place for resting shoes, hats, ties, etc.
4. If there are objective beams and columns, the overall wardrobe design should also consider the left and right wide side panels of the light should be open L-shaped integral panels.
5. The sliding door is designed to the top of the ceiling. The side of the front side of the beam should be sewn from the bottom of the beam to the floor through the same size plate as the beam to ensure that the sliding door can be completely closed when closed.
6. If the overall wardrobe is designed such that the top cabinet is a wooden board that is flattened and the lower cabinet is a sliding door, the side of the front side of the beam should pass through the same size as the beam, from the bottom of the beam to the top of the lower cabinet. The seat is sewn.
7. If the whole wardrobe top cabinet and the lower cabinet are to be designed as traditional flat-opening doors, then the columns and beams should be avoided, and the design width of each door should be the same to ensure the consistency and aesthetic coordination of the overall door. .
8. If the cabinet may touch switch sockets, cable TV, broadband outlets, etc., the overall wardrobe service provider should be evaluated and measured at the progress of the water and electricity wiring to ensure that they can be used reasonably in the future.
Shaving Brush,Shaving Brush Kit,Shaving Brush Set,Shaving Brush Amazon
GUANGZHOU WEIDI TECHNOLOGY CO., LTD , https://www.weidirazor.com