In the last article, Xiao Bian gave everyone an answer to the question of what lubricants were used on treadmills. I believe we should all know what treadmills use. So today, this article, Xiao Bian will share with you, how to add lubricant to the treadmill! As we all know, the special lubricant for treadmills is silicone oil, which is a special anti-static lubricant for running belts of treadmills. It belongs to synthetic oils, but how to add them still requires a correct step and cycle, otherwise it will be counterproductive.
The following small series of detailed steps for everyone to talk about:
1. First of all, stop the machine first to prevent injury during the refueling process. Before the refueling, clean the treadmill, especially the debris and dirt between the running board and the running belt.
2. Then, open the left running belt and pour the lubricant on the running board in the direction of the running belt. The dosage is about 10 ml, and the right side is the same as the left side.
3. Finally, the treadmill is powered within 3KM/H, and the person stands up and moves with the running belt, and he/she uses the conscious treading pressure to run down the area coated with lubricating oil to spread evenly on the running plate.
After the above three simple addition steps, the addition of lubricating oil is completed. It is worth noting that during the addition process, the amount must be added at one time, not too much, not too little, more waste, less without lubrication. This is because it is necessary to have a periodical cycle to add lubricant to the treadmill. The above steps apply to different types of treadmills, but the cycle time for adding different types of treadmills is not the same.
So how about the cycle of adding lubricants to home treadmills and commercial treadmills?
Home treadmills: Since the use rate of home treadmills is not as frequent as that of commercial treadmills, the cycle time is relatively long, assuming that oil is added once every 3 hours or 3 months.
Commercial treadmills: The difference between commercial treadmills and home treadmills is that the use of commercial treadmills is frequent and the wear between the various components may be relatively more, so the cycle of adding lubricants will be shorter. If the oil is replenished once a month for about 12 hours a month, the oil is replenished once every 8 hours or so for 2 months, and once every 4 hours, the lubricating oil is replenished for 3 months.
Because the use of silicone oil is mainly to reduce the friction between the running belt and the running board, to protect the wear-resistant coating on the running board surface, to extend the service life of the running belt and the running board, and to reduce the power consumption of the treadmill. Can reduce static electricity and noise generation even more. Based on this characteristic of silicone oil, we can roughly determine when the treadmill needs to add lubricant.
How to determine the time needed to add treadmill lubricants?
In general, it is sufficient to run the treadmill for 100 hours continuously. Of course, this is only a rough time. The main purpose of adding lubricating oil is to reduce the friction between the running belt and the running board. The friction is too great. On the one hand, the power consumption is increased, and the service life of the running belt, the running board and the motor are all Influencing, therefore, it is necessary to lubricate the treadmill when it feels too much friction. Here are two tips for everyone:
1. When the treadmill is at a standstill, use your feet to force the belt to run backwards. It can be awkward or awkward.
2. When running on a treadmill, set the speed to medium speed, then pull the safety switch down and the running belt stops running immediately.
Xiao Bian summary: said so many people believe that how to give treadmill plus silicone oil has its own ideas, but anyway, Xiao Bian still have to remind everyone in the use of added lubricants need to pay attention to some places: not excessive Use, to prevent friction between the running belt and the drive roller after friction is too small to affect the normal use, the machine has been coated with anti-static lubricant before leaving the factory, please do not rush to add lubricating oil, treadmills professional silicone oil is industrial lubricants Please stay away from children and pets to avoid swallowing.
Stroller,Multi-Functional Infant Stroller,Double Stroller,Lightweight Stroller
NINGBO BABY FIRST BABY PRODUCTS CO.,LTD. , https://www.maxinfcarseat.com